Maple Valley, King County
In Maple Valley, relining a chimney is priced from $1,900. That buys stainless steel liner from the appliance to the cap, with no stretch of flue left bare. Height, diameter, insulation and the appliance at the bottom set the final figure, which we give in writing after a camera has been through the flue. A liner is not routine upkeep. It is the fix when the existing flue is cracked, the wrong size, or missing.
Typical investment
From $1,900
Book an inspection
Book your $99 inspection
$99 plus tax, deducted when you approve the repair
Not sure where to start
Pick what you're seeing at your Maple Valley home — we'll point you to the right fix.
What we do
The same crew, the same written quote — for Maple Valley homes.
Level 1 review of the accessible parts, stepped up to a Level 2 camera pass when those parts cannot settle the question
Learn more
The flue brushed along its full height with heads chosen for its shape and material
Learn more
An assessment in photos that tells weathering apart from structural failure
Learn more
Each flue measured, or the whole crown when one cap will cover several flues
Learn more
Burner, pilot assembly and igniter cleaned and tested
Learn more
Photos of the crown and of all four faces before work begins
Learn moreRanges shown for orientation — the exact figure is written up on-site, after the inspection.
Most of Maple Valley was built recently: Census estimates give a median construction year of 2001. Older flues exist all the same. About 7.3% of the city's housing units date from the 1960s and 1970s and a further 1.5% from before 1960, the same estimates show, and those are the chimneys most likely to have clay tiles that have seen fifty or more winters. Newer homes meet relining from another direction: an owner adds a wood stove or an insert, and the appliance needs a flue matched to its outlet.
The 2020 to 2024 American Community Survey counts a small number of Maple Valley homes whose main heating fuel is wood, and close to one in ten in the rural Hobart area beside the city. Housing there is older as well: the same survey gives Hobart a median construction year of 1985, with about a quarter of its units built in the 1960s and 1970s.
A stove or insert that burns all day sends far more heat and flue gas up the chimney over a winter than an occasional fire does. Connected to an old, wide flue, it drafts lazily and the gases cool before they leave. A stainless liner matched to the appliance collar keeps them moving. For a household that depends on the stove, we size the liner to the manufacturer's figures and insulate it where they require.
Every chimney relining we do in Maple Valley includes:
Smoke coming back into the room, or a smell that won't go? Book the inspection first.
Book nowA flue fails quietly. Tile joints open, a tile cracks after a hot fire, or condensation from an oversized flue eats at the mortar between sections. From the hearth everything looks normal. The camera shows gaps where heat and smoke can reach the structure around the chimney. We do not presume what a Maple Valley home has inside its chimney. We scan it, measure it and show you the footage before proposing a liner.
Under the Clean Air Agency's rules, a first-stage ban shuts down open fireplaces along with whatever stove or insert lacks a certification label. Certified units are only stopped when the agency moves to its second stage. That gap is one reason owners replace an open fireplace with a certified insert, and the agency notes that solid fuel devices sold in Washington must meet the state's emission standards.
An insert changes what the chimney has to do. Its outlet is much smaller than a fireplace flue, so the installation needs a liner from the insert collar to the cap. Skip that step and smoke lingers in a cold, oversized flue, where it condenses and stains the masonry. Done properly, the new appliance and its liner are planned as one job.
The camera records the state of the old flue. We measure its height and cross-section and read the appliance's requirements from its plate or manual.
Liner diameter, length, insulation, top hardware and labor are listed line by line. Nothing is ordered until you have approved it.
The flue is swept so the liner slides in clean. Damaged tiles that would block it are dealt with first.
Standing at the chimney top, the crew lowers the liner in a single piece, insulates it to specification, and joins it to the appliance or fireplace throat.
Top plate and cap close the crown. A last camera run gives you a record of what was installed.
What this work is quoted at for Maple Valley homes — the exact figure comes from the $99 on-site inspection, credited toward the work.
| Service | Price in Maple Valley | What that covers |
|---|---|---|
| Chimney Relining | From $1,900 | Full-length stainless liner, sized to the appliance |
| Chimney Sweep | $189–$459 | Full flue swept, Level 1 inspection included |
| Chimney Inspection | $99 plus tax | Level 1 visual; Level 2 adds a full camera scan |
| Chimney Repair | From $375 | Masonry repair — brick and mortar, scoped after diagnosis |
| Chimney Cap Installation | $265–$850 | Stainless cap fitted; multi-flue and custom at the top |
Ranges are what these jobs are quoted at in Maple Valley. The exact figure is set on site after a $99 inspection (credited toward the job if you go ahead), and you approve it before any work starts.
Maple Valley is a city in the Cedar River valley, about 10 miles southeast of Renton, on the Cedar River, with homes with a median build year of 2001, about six in ten of them built in the 1990s and 2000s.
Maple ValleyKing County, WA · 47.367, -122.045
Before and after
Illustrations of what each repair changes on a typical chimney — not photos of a specific job.
Before
After
Before
After
Before
After
Four steps, each one on paper — so you always know what happens next.
Choose a genuine opening on the crew's calendar. Confirmation is immediate.
Liner, crown, cap, flashing and masonry examined in order — each finding photographed.
One document, plain numbers, covering only the work your chimney genuinely needs.
The repair is completed, then handed over with before-and-after photos of every item.
From $1,900. A short, straight flue serving one appliance is near that floor. A tall chimney, a large diameter or added insulation raises it, and the written quote spells out why.
Only a camera can tell. Our $99 plus tax visit includes that scan, and a relining quote you accept is lowered by that $99.
We could not confirm Maple Valley's own permit list for this work, so we check with the city before a job that changes an appliance or a flue. At rural addresses outside the city limits, King County's permit office is the one to ask.
When no mortar or poured insulation has to cure, yes. If it does, we give you the waiting time in writing.
A $99 on-site inspection, a written quote before any work, and photos of every item we touch.
